After class on Tuesday, members Steven and Jesse went to the machine shop to get wood cut for the actual board. The bases of the maze were cut into three pieces of equal sizes (8" by 12") and numerous pieces were cut to form the inner walls of the maze which each vary in size greatly. The Arduino program was downloaded, but the code has yet to be finished due to lack of knowledge of Arduino language. The pieces that had been cut earlier in the week were then taken to another woodshop to make them look better for the final product. With this done, the inner walls and the connecting ramps were attached, completing the interior design of the project. Another thing to note, extension cables and another Servo motor arrived in the mail, which will help us figure out the set up for the design and for the Arduino code.
The refined design
attempting to code the Arduino
After cutting the wood
Extension Cables
No comments:
Post a Comment